Kleenmaid HALFFRAME90 - Manual (Page 10)

Description of the hood - Fig. 1
1 Control panel
2 Grease filter
3 Grease filter release handle
4 Halogen lamp
5 Vapour screen
6 Telescopic chimney
7 Air outlet (used for filter version only)
Operation –
Model with electronic controls
1- Motor OFF button
2- ON button and motor speed selection button 1 - 2 - 3 - 1 - 2 -
. . . .
3- Speed 1 LED
4- Speed 2 LED and metal grease filter saturation LED (in this
latter case, the LED will flash - See instructions on grease filter
cleaning).
5- Speed 3 LED and active carbon filter saturation LED (in this
latter case, the LED will flash - See instructions on active
carbon filter replacement).
Warning!
The active carbon filter saturation LED is not activated.
In order to activate the active carbon filter saturation indicator,
press buttons 2 and 7 simultaneously for 3 seconds. Initially,
only LED 4 will flash, then after the 3 seconds have passed,
LED 5 will also start flashing, indicating that the active carbon
filter saturation control system is active.
To switch off the system, re-press the same two buttons: after
3 seconds LED 5 will stop flashing and the device will be
switched off.
6 - Intensive speed LED
7 - Intensive speed ON switch
This speed should be used when the concentration of cooking
fumes or odours is particularly strong (for example when frying,
cooking fish etc.).
The fast speed will run for about 5
minutes and then return to the speed previously set automatically
(1, 2 or 3), or switch off if no speed was selected.
To turn off the fast speed, before the end of the 5 minutes, press
button 1 or button 2.
8 - OFF lamp button
9 - ON lamp button
If the hood fails to operate correctly, briefly disconnect it from the
mains power supply for almost 5 sec. by pulling out the plug. Then
plug it in again and try once more before contacting the Technical
Assistance Service.
Operation –
Model with button panel
Description of control panel and hood operation
a. on/off light switch
b. on/off aspiration switch and minimum power selection
c. medium power selection aspiration switch
d. maximum power selection aspiration switch
e. operating gauge
(foreseen in the model with round buttons)
Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the cooker hood suction is switched
on for 5 minutes prior to cooking and to leave in operation during
cooking and for another 15 minutes approximately after terminating
cooking.
1 2 3 4 5 6 7
8 9
a b c d
a b c d e
INSTRUCTION ON MOUNTING AND USE
Consult the designs in the front pages referenced in the text by alphabet letters. Closely follow the instructions set out in this manual. All responsibility,
for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined.
GB