Kleenmaid KEY60 - Manual (Page 5)

5
Using the rangehood
• The rangehood is fitted with one motor having
several speed. Best results are obtained by
using a low speed for normal conditions and
high speed when odours are more concentrated.
Turn the rangehood on a few minutes before
you start cooking then you will get an
underpressure in the kitchen. It should be left
on after cooking for about 15 minutes or until
all odours have disappeared.
The control switches are located on the unit’s
front panel:
1- Motor OFF button
2- ON button and motor speed selection button 1 -
2 - 3 - 1 - 2 - . . . .
3- Speed 1 LED
4- Speed 2 LED and metal grease filter saturation
LED (in this latter case, the LED will flash -
See instructions on grease filter cleaning).
Once the grease filters have been cleaned, press
button 1 for about 3 seconds until you hear the
acoustic signal (beep): the LED 4 will now stop
flashing.
5- Speed 3 LED and active carbon filter saturation
LED (in this latter case, the LED will flash -
See instructions on active carbon filter
replacement).
Once you have replaced the charcoal filter,
press button 1 for about 3 seconds until you
hear the acoustic signal (beep).
LED 5 will now stop flashing.
Warning!
The active carbon filter saturation LED is not
activated.
In order to activate the active carbon filter
saturation indicator, press buttons 2 and 7
simultaneously for 3 seconds. Initially, only
LED 4 will flash, then after the 3 seconds have
passed, LED 5 will also start flashing,
indicating that the active carbon filter saturation
control system is active.
To switch off the system, re-press the same two
buttons: after 3 seconds LED 5 will stop
flashing and the device will be switched off.
6 - Intensive speed LED
7 - Intensive speed ON switch
This speed should be used when the
concentration of cooking fumes or odours is
particularly strong (for example when frying,
1 2 3 4 5 6 7 8 9
cooking fish etc.). The fast speed will run for
about 5 minutes and then return to the speed
previously set automatically (1, 2 or 3), or
switch off if no speed was selected. To turn off
the fast speed, before the end of the 5 minutes,
press button 1 or button 2 .
8 - OFF lamp button
9 - ON lamp button
If the hood fails to operate correctly, briefly
disconnect it from the mains power supply for
approximately 5 seconds by switching off at the
wall and pulling out the plug. Then plug in again,
turn on the switch and try again before contact
your nearest authorised Kleenmaid Service Agent.
Correct ventilation
If the rangehood is to work correctly there must be
an underpressure in the kitchen. It is important to
keep the kitchen windows closed and have a
window in an adjacent room open.
Important to know
Not applicable for recirculation. Great care must
be taken if the rangehood is used at the same time
as a burner or fireplace (e.g. gas, diesel, coal or
wood heaters, water heaters, etc.), as the
rangehood will expel air which is required by
these other appliances. Attend to it by opening a
window. The negative pressure in the room must
not exceed 0,04 mbar to prevent fumes being
drawn back into the room by the rangehood.