Kleenmaid RHSGFOCUS - Manual (Page 8)

Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the Rangehood suction
is switched on for 5 minutes prior to cooking and to leave
in operation during cooking and for another 15 minutes
approximately after terminating cooking.
Description of the Rangehood - Fig. 1
1 Control panel
2 Grease filter
3 Grease filter release handle
4 Halogen lamp
5 Vapour screen
6 Telescopic chimney
7 Air outlet ( Ducting/Filter Model Only! )
Operation –
Model with electronic controls
1 - Motor OFF button
2 - ON button and motor speed selection button 1 - 2 - 3 -
1 - 2 - . . . .
3 - Speed 1 LED
4 - Speed 2 LED and metal grease filter saturation LED
(in this latter case, the LED will flash - See instructions
on grease filter cleaning).
5 - Speed 3 LED and active carbon filter saturation LED
( Ducting/Filter Model Only! - in this latter case, the
LED will flash - See instructions on active carbon filter
replacement).
Warning! The active carbon filter saturation LED is not
activated. In order to activate the active carbon filter
saturation indicator, press buttons 2 and 7 simultaneously
for 3 seconds. Initially, only LED 4 will flash, then after
the 3 seconds have passed, LED 5 will also start
flashing, indicating that the active carbon filter saturation
control system is active. To switch off the system, re-
press the same two buttons: after 3 seconds LED 5 will
stop flashing and the device will be switched off.
6 - Intensive speed LED
7 - Intensive speed ON switch
This speed should be used when the concentration of
cooking fumes or odours is particularly strong (for
example when frying, cooking fish etc.). The
fast speed will run for about 5 minutes and then return
to the speed previously set automatically (1, 2 or 3),
or switch off if no speed was selected. To turn off the
fast speed, before the end of the 5 minutes, press button
1 or button 2 (see page 13).
8 - OFF lamp button
9 - ON lamp button
If the Rangehood fails to operate correctly, briefly disconnect
it from the mains power supply for approx. 5 sec. by pulling
out the plug. Plug it in again and try once more
before contacting the Technical Assistance Service.
1 2 3 4 5 6 7 8 9
Consult the designs in the front pages referenced in the text by alphabet letters. Closely follow the instructions set out in this
manual. All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in
this manual is declined.
Ducting/Filter
Model Only!
INSTRUCTION ON MOUNTING AND USE GB