Kleenmaid TO5A - Manual (Page 4)

INSTALLING THE OVEN CHANGING THE OVEN LIGHT BULB
6 7
IMPORTANT: Connection to electrical mains must only be performed by a
licensed electrical contractor. All care must be taken to ensure the installation
is properly earthed and conforms to all local codes.
Refer to GENERAL DATA (page 3) for details of the particular cut-out and depth
dimensions required for the model oven installed. Prepare the cut-out in the
cabinet and ensure that side slide rails are available to allow the underside of the
oven to be supported whilst allowing the unit to slide in.
Use the 4 screws provided to secure the front trim side rails to the cabinet front.
Scala ovens may be installed in any type of heat resistant cabinet (we suggest
you speak to your cabinet maker for further information).
When installed as a wall unit, ensure that the upper-rear section of the cabinet
has an 80-90 mm depth vent.
NOTE: Any vertical cupboard panels immediately beside the wall oven must be
sealed completely to obtain the best result from your oven.
IMPORTANT: So that your Scala oven maintains its efficient sealing
capacity for the life of the appliance, NEVER USE THE DOOR AS A LEVER
(especially when the oven is being installed into its recess). Similarly,
undue pressure must never be placed on the oven door when it is open.
Please contact our Customer Call Centre on 1 800 072 144 to arrange for your
FREE In-Home Demonstration.
Our trained Demonstrator will make an appointment to visit you in your home and
explain how to confidently use and care for your appliance.
Please note that we may not have a Kleenmaid Demonstrator in some regional
areas. In this case we will organise a step-by-step telephone demonstration to
ensure you are able to achieve the best result from your appliance.
1. Remove cover (A) by unscrewing in an
anticlockwise direction.
2. Replace bulb (15W SES) Available through
Kleenmaid Stores and Customer Call Centre
on 1 800 072 144.
3. Remount cover (A)
REMOVING THE OVEN DOOR
Removing the door allows easy access to the interior of the oven for cleaning. To
do so:-
1. (FIG 1) At either side of the door, the hinges (A) have two clips (B) which can be
moved. Normally these remain flat against hinges (A). Open the door fully and
hook the clips (B) to the part (C) of the hinges. The door assembly can now be
removed.
2. Lift the door towards the outside (FIG 2). Two movements are required, up and
towards yourself, gripping the door near each hinge.
3. To replace the door, insert the hinges completely into the grooves.
4. Unclip the two clips (B) which hold the two hinges - THIS IS IMPORTANT!
The door is now in place.
FREE IN-HOME DEMONSTRATION
FIG 1 FIG 2