Kleenmaid MWTK1S - Manual (Page 6)

MICROWAVE INSTALLED BY ITSELF
(“Integrated Flush”)
1. Mark out cutout positions (Fig 1 & 2) ensuring
sufficient depth is available as shown
2. Fit baseboard with two bearer blocks positioned as
(Fig 1 & 2) to suit microwave.
3. Position Microwave on blocks and plug in power
cord to suitable power point.
4. Position surround to line-up with Microwave allowing
equal clearance on all four sides.
5. Fix the two mounting bars to the front fascia with
four screws supplied.
6. Position front section of trim to the mounting bars
and press onto locater clips.
MICROWAVE INSTALLED OVER WALL OVEN
(“Integrated Flush”)
1. Mark out cutout as Fig 3 ensuring sufficient depth is
available (Fig 1 & 2)
2. Mark out Wall Oven cutout according to model
number setting heights of both cutouts to suit your
own requirements.
3. Build up an enclosure box with open top as Fig 2
and fit bearer blocks positioned as shown in Fig 1, 2
& 3.
4. Position microwave on blocks and plug in power
cord to a suitable power point.
5.
On Wall Ovens with top flue outlet an angled flue
extension is required to allow the flue pipe to be
offset. This extension must give the maximum
possible angle without coming into contact with
combustible material (see Fig 3)
or position a non-
combustible heat shield as shown in Fig 2 (ie metal
spaced off from timber by 15mm).
3