Kleenmaid DCTBBQ - Manual (Page 8)

8
Installation
These instructions are provided for qualified installers as
a guide to installation, adjustment and maintenance in
conformity with current laws and standards. Service must
always be performed with the appliance disconnected
from the electricity.
Operation (Fig. 3 and 4)
The appliance is designed to be built in to a work surface
as shown in the figure. Prepare the edge of the hob with
the sealant provided (Fig. 5).
Electrical connection
Before connecting to the electricity, make sure that:
- the characteristics of the system match the data on
the bottom of the hob;
- the system has an effective earth connection
compliant with current standards and laws. An earth
connection is required by law.
- If the appliance has no cable and/or plug, use
material suitable for the absorption indicated on the
registration plate and for the working temperature.
The cable must not reach a temperature higher than
50 °C above room temperature in any point.
If you want a direct connection to the mains, you must
install an omnipolar switch with a minimum opening
between the contacts of 3 mm, dimensioned for the
load indicated on the plate, and conforming to current
standards (the yellow/green wire must not be interrupted
by the switch). The omnipolar socket or switch must be
easy to reach when the appliance is installed.
Note: The manufacturer declines all liability if the
usual accident prevention standards and the above
instructions are not followed.
Installation instructions