DCS DW-24SS User Manual
Page 23
User Instructions
22
TECHNICAL DATA
Width
Depth measured flush with the
outer edge of the control panel
Height
Capacity
Water supply pressure
Electrical characteristics
23-1/2” 23-9/16”
Free standing: 23 5/8”
from 33 1/2” to 34-1/4”
Standard place settings
min. 50 - max. 900 KPa (min. 0.5 - max. 9 bar)
See rating plate
The temperature monitoring system has failed.
• Switch the dishwasher off, switch it back on and restart the washing program.
If the alarm recurs, call the DCS Customer Service Department.
The dishwasher fail to draw water.
Check that:
• The water supply tap is open.
• The filter in the water intake hose is not clogged.
• The water intake hose is not kinked or bent.
Switch the dishwasher off and back on. If the problem is resolved the washing
program will resume from where it was halted.
If the fault persists, call the DCS Customer Service Department.
The dishwasher fails to drain.
Check that:
• The flexible drain hose is not kinked or obstructed;
• The water drain pipe is not obstructed;
• The dishwasher filter is not clogged.
Switch the dishwasher off and back on. If the problem is resolved, the washing
program will resume from where it was halted.
Otherwise, if the fault persists, call the DCS Customer Service Department.
In the event of error codes not included in this table, call the DCS Customer Service
Department.
E4
E5
E6