Kleenmaid BI80X - Manual (Page 9)

13 12
Your oven carries the BRANDT label, it has an upper ventilation system and the hob
can therefore be fitted directly into the worktop above the oven in the higher position.
● It is essential that an air inlet of 30 cm 2 be made in the left or right wall of the oven
housing unit.
Reminder: the hob’s thermal safety devices prevent its simultaneous use with an oven
in pyrolysis mode.
,,
,,,,,
,,,,,
,,,,,
30 cm2
Building in above an oven
Example shows air inlet through the rear
right
It is essential that you install an insulation kit between the oven and the hob (available
from your dealer’s After Sales Service). This arrangement restricts installation of the
oven to the lower position in the unit.
,,,,,
30 cm
,
,
,
,
,
5 cm
air
gap
,
,
,
80mm
FRONT OF UNIT
AIR OUTLET
AIR INLET
Above an empty unit or drawer
Above an oven of another make
Above an oven of the same make
30 cm 2
air inlet
75X 1652
Installation options
● above an empty unit or drawer
● above an oven of another make
● above an oven of the same make
Your induction hob must always be well-ventilated.
Make sure that the flow of air through the ventilation grille at the back is completely
unobstructed.