beautypg.com

Mounting the built-in cooktop, Caution – Kleenmaid CH605CM User Manual

Page 9

background image

Instructions for use, mounting and connection

9

Mounting the built-in cooktop

Caution !

To avoid any possible hazard, the appliance
may be installed by qualified personnel only.

Panels and furniture lining of the kitchen
cabinet receiving the hob must be treated with
temperature resistant adhesives (100°C),
otherwise they might be discoloured or
deformed because of inadequate temperature
resistance.

The cooking hob is intended for building into the
worktop above the kitchen element of 600 mm
width or more.

After the installation of built-in hob make sure
that there is free access to the two fixing
elements in front.

Suspended kitchen elements above the
cooktop must be installed at such distance to

provide enough room for comfortable working
process.

The distance between the worktop and the
hood must be at least such as indicated in the
instructions for installation of the kitchen hood,
but in no case it may be less than 650 mm.

The smallest distance between the edge of the
appliance and the adjacent high kitchen
cabinet is 40 mm.

The use of hard wood decorative borders
around the worktop behind the appliance is
allowed, in case the minimum distance remains
as indicated on the installation illustrations.

Minimum distance between the built-in cooktop
and rear wall is indicated at the illustration for
the installation of the built-in cooktop.

The appliance may be installed in any worktop
with a thickness from 30 mm to 50 mm.

Dimensions of the built-in hob opening

Installation procedure

Worktop must be placed absolutely horizontal.

Suitably protect the edges of the cut aperture.

By means of the supplied screws 4 (or 6 by
some models) fasten the supplied tightening
brackets 4 (or 6 by some models) fasten to the
front and the rear side of the cooking hob and
to the prepared aperture.

Connect the cooking hob to the mains power
supply (see instructions for the connection of
the cooking hob to mains power supply).

Insert the hob into the cut aperture.

Press the hob firmly towards the worktop from
above.