Kleenmaid IB31D - Manual (Page 7)

9 8
For the user
You are worried that
your hob is not
functioning properly...
Call your After Sales Service.
Check the connections and the mains
connection are correct.
This is quite normal
The electronic circuit is dysfunctionning
Your hob has been wrongly connected.
Your hob has been wrongly connected.
This is caused by the distribution of power
between two induction cooking zones.
The electronic system is being cooled.
See section choice of pans.
The pan you are using is unsuitable for
cooking by induction or has a diameter
less than 12 cm.
Inspect the fuses and the circuit breaker.
The appliance has no power. Either the
power supply or the connection is
faulty.
The hob does not work, the display indicates
another message.
When you switch the appliance on, your mains
cuts out.
When you switch it on, only one side of your hob
functions.
Your hob makes a slight clicking noise.
The fan continues operating for a few minutes after
your hob is switched off.
After having switched on a heating zone, the lights
on the keypad continue to flash.
Check the connections. The supply vol-
tage is too high.
Your hob has been wrongly connected.
The hob does not work, the display indicates an
intermittent «Point».
The hob does not work. The lights on the keypad
stay off.
The display indicates the message F7 F7 The electronic circuits have overheated. See section building in.
The electronic system is on standby, as
with any other electronic appliance
(TV, transformer).
The top of your hob is always slightly warm (even
when off)
... this does not necessarily mean there is a fault.
Always check the following points first.
WHAT TO DO POSSIBLE
CAUSES
YOU NOTICE
THAT...
NOTHING: see section
with notes on connection
Normal operation
When you switch the appliance on a display
lights
See “how induction works”
This is quite normal
For the user
Cleaning
TYPE OF STAIN
Minor
Accumulated burnt-on
stains
Rings and traces of limescale
Burnt-on stains following
sugar spillage, melted
aluminium or plastic.
WHAT TO DO ACCESSORIES
REQUIRED
Soak the area to be cleaned
thoroughly with hot water,
then wipe clean
cleaning sponges
Soak the area to be
cleaned thoroughly with hot
water, if necessary, finish
off with the rough side of a
scouring sponge, then wipe
clean.
cleaning sponges
STAINLESS STEEL - A soft, soapy cloth is all that you need to use on Stainless Steel
• Apply hot white spirit
vinegar to the stain, leave to
act then wipe off with a soft
cloth.
• Or use a commercial
cleaner.
Special Stainless Steel Cleaners can be used to tackle persistent stains
Special ceramic hob
cleaning paste
• Use a special ceramic hob
scraper to loosen the resi-
due
• Or apply a special
ceramic hob cleaner to the
surface, preferably one
which contains silicone
(protective action). Special ceramic hob
cleaner
corrosive foodstuffs acids.
What to avoid · Harsh powders or wire wool cleaning pads, silver dip cleaners