Kemppi MMT 42C User Manual
Page 11
EN
If gun's neck gets too worn or damaged, you can replace it by unscrewing it from the gun
body and replacing with a new one.
NOTE!
Check the tightness of the neck daily. A loose neck can cause voltage loss and excess heat in
the gun body.
If you wish to lock the neck in its position, open the torx screw under the rubber collar of the
bending support and remove one of the three washers.
NOTE!
If the neck is locked, remember to loosen the torx screw before trying to unscrew the neck.
9
© Kemppi Oy / 1131
See also other documents in the category Kemppi Equipment:
- FastCool 10 (12 pages)
- ArcFeed 300P (20 pages)
- KempCool 10 (12 pages)
- KempCool 40 (14 pages)
- KempactCool 10 (24 pages)
- Procool 10 (11 pages)
- Procool 30 (9 pages)
- KMS 500 (16 pages)
- KM 500 (18 pages)
- MSF 57 (32 pages)
- MF 33 (16 pages)
- MF 29 (18 pages)
- KMS 400 MVU (16 pages)
- FastMig Pulse 450 (30 pages)
- MXF 67 (36 pages)
- GT02SW (18 pages)
- FastMig MS 300 (22 pages)
- SF 54 (14 pages)
- KMS 400 AS (18 pages)
- KM 400 MVU (18 pages)
- MXP 38 (30 pages)
- FastMig X 450 (32 pages)
- FastMig 520 (16 pages)
- MR 300 (14 pages)
- M 420MV (16 pages)
- AS (10 pages)
- Evo 300 (20 pages)
- RA (38 pages)
- Pulse 2800 (17 pages)
- Pulse 3000 MVU (24 pages)
- MIG 2520 (12 pages)
- MIG 2530 (16 pages)
- DT 400 (34 pages)
- ARC800 (16 pages)
- Pulse TCS (38 pages)
- KempArc DT400 (28 pages)
- Kempomat 2100 (14 pages)
- Kempomat 4200 (26 pages)
- Promig 100 (19 pages)
- ProMXE Automotive panel (20 pages)
- Pro Evolution 4200 (17 pages)
- Promig 300 (22 pages)
- Protig 410 (28 pages)
- Protig 511 (37 pages)
- Promig 200 ML (18 pages)