2 general view of the machine, 3 distribution network, 4 cable connections – Kemppi Adaptive 180 User Manual

Page 8

2.2

general View OF tHe MaCHine

1. Welding gun

2. Earthing cable

3. Main switch

4. Supply voltage cable

5. Shielding gas hose connector

2.3

distriButiOn netwOrk

All regular electrical devices without special circuits generate harmonic

currents into distribution network. High rates of harmonic current may cause

losses and disturbance to some equipment.
WARNING: This equipment does not comply with IEC 61000-3-12. If it is

connected to a public low voltage system, it is the responsibility of the

installer or user of the equipment to ensure, by consultation with the

distribution network operator if necessary, that the equipment may be

connected.

2.4

CaBle COnneCtiOns

Connection to the mains

The machine is equipped with a 3.3 m long supply voltage cable and plug.

Connect the supply voltage cable to the mains.

NOTE!

The fuse size needed is 16 A delayed.

If you use an extension cord, its cross-sectional area should be at least as

large as the supply voltage cable’s (3 x 2.5 mm²). The maximum length for the

extension cord is 50 m.

inar

y / 1117