Siting the machine – Kemppi 2200 Master User Manual
Page 5
S11
X11
X12
01
R12
2.2. SITING THE MACHINE
By siting of the machine you should take into attention the following:
- Site the machine on a fixed dry base, from which there doesn’t come any dust etc. into
suction air. See to that the machine is positioned away from the line of particle spray, created by
grinding tools etc. Preferably site machine somewhat higher above the floor level.
- See to that in front of the machine as well as at the rear of the machine there is at least 20 cm
(8.0 inches) free distance to allow good circulation of the cooling air through the machine.
- Protect the machine against hard rain and in hot circumstances against direct sunshine. Ensure
the free circulation of the cooling air.
MASTER 2200/0530 – 5
© KEMPPI OY
See also other documents in the category Kemppi Equipment:
- FastCool 10 (12 pages)
- ArcFeed 300P (20 pages)
- KempCool 10 (12 pages)
- KempCool 40 (14 pages)
- KempactCool 10 (24 pages)
- Procool 10 (11 pages)
- Procool 30 (9 pages)
- KMS 500 (16 pages)
- KM 500 (18 pages)
- MSF 57 (32 pages)
- MF 33 (16 pages)
- MF 29 (18 pages)
- KMS 400 MVU (16 pages)
- FastMig Pulse 450 (30 pages)
- MXF 67 (36 pages)
- GT02SW (18 pages)
- FastMig MS 300 (22 pages)
- SF 54 (14 pages)
- KMS 400 AS (18 pages)
- KM 400 MVU (18 pages)
- MXP 38 (30 pages)
- FastMig X 450 (32 pages)
- FastMig 520 (16 pages)
- MR 300 (14 pages)
- M 420MV (16 pages)
- AS (10 pages)
- Evo 300 (20 pages)
- RA (38 pages)
- Pulse 2800 (17 pages)
- Pulse 3000 MVU (24 pages)
- MIG 2520 (12 pages)
- MIG 2530 (16 pages)
- DT 400 (34 pages)
- ARC800 (16 pages)
- Pulse TCS (38 pages)
- KempArc DT400 (28 pages)
- Kempomat 2100 (14 pages)
- Kempomat 4200 (26 pages)
- Promig 100 (19 pages)
- ProMXE Automotive panel (20 pages)
- Pro Evolution 4200 (17 pages)
- Promig 300 (22 pages)
- Protig 410 (28 pages)
- Protig 511 (37 pages)
- Promig 200 ML (18 pages)