Delta 50-875 - Manual (Page 7)

7
Never secure the air cleaner hardware to drywall, drop ceiling tile/frame, or other non-structural
members.
This unit weighs approximately 60 pounds. When mounting overhead, be certain that the unit is
securely fastened and supported.
1. Locate the four 1" eye bolts and the four 1/4-20 flange nuts supplied with the unit.
2. Use a flat blade screwdriver (not supplied) to remove the four screws (C) Fig. 5 from the top of air cleaner (D).
3. Thread one flange nut on each bolt approximately 3/4".
4. Thread the eye-bolts (F) Fig. 6 into the four holes where the screws were removed in STEP 2.
Be certain that the flange nuts are tightened against the surface of the air cleaner.
When suspending the air cleaner from the ceiling or other overhead support, use steel s-hooks that are a
minimum of 1/4".
Thread all lag hooks at least 1-1/2" into the supporting structural members.
MOUNTING THE AIR CLEANER TO THE CEILING OR OVERHEAD SUPPORT
Keep a minimum of seven feet between bottom of air cleaner and the floor surface.
DO NOT use rope, cable, or power cord to suspend the unit from the ceiling. Use chain rated for a minimum of
a 150 lb. working load.
IMPORTANT: When determining a location to mount the unit, the air cleaner will operate more efficiently when
the air flow is unrestricted. Do not locate the unit in a corner or near any heating or cooling vents.
Fig. 5
Fig. 6
NOTE:
NOTE:
NOTE:
C
D
F
ON/OFF SWITCH
The Air Cleaner is equipped with an in-line rocker switch
(M) Fig.7, located on the power cord (N). To start or stop
the motor, press downward on the rocker switch,
according to the markings on the side. When you are
finished with the air cleaner, turn the switch off rather
than unplug the unit.
NOTE: The ON-OFF Switch must be turned “ON” before
using the remote control feature.
Fig. 7
N
M