Dixon Kohler Ram Ultra 27 - Manual (Page 42)

MAINTENANCE
42
-Dixon
Deck Belt
Park on a level surface. Apply parking brake. 1.
lower the deck into the lowest cutting 2.
position.
Remove bolts from belt shields and remove
3.
shields.
Remove any dirt or grass that may have
4.
accumulated around the cutter housings and
entire deck surface.
Carefully roll the belt over the top of the
5.
cutter housing pulleys and remove belt.
Deck belt installation
NOTE: For ease in installing the deck belt, refer to
the routing decal on bottom of seat.
Wrap the deck belt around the electric clutch 1.
pulley that is located on the engine shaft.
Route the belt forward between the EZT
2.
(E-Series Zeroturn Transaxles) and up onto
the deck.
Place belt around spring loaded idler pulley.
3.
Wrap the belt around the stationary idler 4.
pulley and around the mandrel housings.
Push inward on the idler arm and carefully
5.
route belt over stationary idler pulley. Once
belt is properly routed, slowly release idler
arm to tension belt.
Double check belt routing to make sure it
6.
matches the routing decal, and the belt does
not have any twist. Correct as needed.
Adjust tension with deck eyebolt.
7.
Replace belt shields on both mandrel 8.
housings and secure with fasteners.
front deck2
Removing deck belt
2
8061-021
1. Clutch pulley
2. Deck belt
Belt routing, deck belt
1
2
Belt Shields