JLCooper MLA-XLR - Manual (Page 5)

3
Setting up the MLA-XLR
Connections
The MLA-XLR is refreshingly simple to use. There are no settings
to configure. Just plug in the power supply and connect two MLA-
XLRs together with a pair of standard mic cables. Then, connect
your MIDI gear as you would normally. Do not use ground lifters,
signal splitters or audio transformers on the XLR cables between
the MLA-XLRs.
Figure 1 – Connecting 2 MLA-XLRs
Using with MLA-1 or MLA-10
The MLA-XLR can be used with the MLA-1 and MLA-10 with
some custom wiring. See the following page for details.
As with the MLA-1 and MLA10, the MLA-XLR can drive
multiple MLA-XLRs, MLA-1s and MLA-10s. However, the
usable distance will decrease with each additional receiver.
Note: As with any amplifier, do not connect multiple outputs
together. This can damage your MLA-XLR, MLA-1 or MLA-10.
The MLA-XLR cannot supply power or derive its power from an
MLA-1 or MLA-10.
MLA-XLR
PS
XLR MIDI MLA-XLR
PS
MIDI