JLCooper MX Eclipse - Manual (Page 6)

Using as an Expander with an Eclipse CX
In this mode of operation, the Eclipse MX will be used as an
expansion unit to an Eclipse CX adding fader functionality to the
system. Up to four expander Eclipse MX controllers can be
connected to an Eclipse CX. In this mode of operation, the Eclipse
MX connects to theEclipse CX Eclipse CX using the JLCooper
Expansion Cable.
Configuring the the Eclipse MX
Before connecting the Eclipse MX to the Eclipse CX, the unit
address must be set. The unit address of the connected Eclipse
MX is set by the DIP switches on the rear of the unit.
Eclipse MX Mode Select DIP Switches
Address Faders Switch 4 Switch 3 Switch 2 Switch 1
Expander #1 1-8 Off (Up) Off (Up) Off (Up) Off (Up)
Expander #2 9-16 Off (Up) Off (Up) Off (Up) On (Down)
Expander #3 17-24 Off (Up) Off (Up) On (Down) Off (Up)
Expander #4 25-32 Off (Up) Off (Up) On (Down) On (Down)
DIP Switch Settings in Expander Mode
Note: The DIP Switches are read when the unit is powered on. If the
states of the DIP Switches are changed, you must power cycle the
Eclipse MX before the changes take effect.
6