Jetway Computer JBC370F33 - Manual (Page 40)

35
400MHz; 533MHz..
3-12 Password Setting
You can set either supervisor or user password, or both of them. The differences are:
Supervisor password:
Can enter and change the options of the setup menus.
User password: Can only enter but do not have the right to change the options of
the setup menus. When you select this function, the following
message will appear at the center of the screen to assist you in
creating a password.
ENTER PASSWORD:
Type the password, up to eight characters in length, and press . The password
typed now will clear any previously entered password from CMOS memory. You will be
asked to confirm the password. Type the password again and press . You may
also press to abort the selection and not enter a password.
To disable a password, just press when you are prompted to enter the password.
A message will confirm that the password will be disabled. Once the password is
disabled, the system will boot and you can enter Setup freely.
PASSWORD DISABLED.
When a password has been enabled, you will be prompted to enter it every time you try to
enter Setup. This prevents an unauthorized person from changing any part of your system
configuration.
Additionally, when a password is enabled, you can also require the BIOS to request a
password every time your system is rebooted. This would prevent unauthorized use of
your computer.
You determine when the password is required within the BIOS Features Setup Menu and
its Security option. If the Security option is set to “System”, the password will be required
both at boot and at entry to Setup. If set to “Setup”, prompting only occurs when trying to
enter Setup.
3-13 Load Standard/Optimized Defaults
Load Standard Defaults
When you press on this item, you get confirmation dialog box with a message