Jetway Computer NC94 - Manual (Page 36)

31
Suspend Mode
The optional settings are: Disabled;1Min,2 Min;4 Min;8 Min;10 Min;20 Min;30 Min;40
Min;50 Min;60 Min.
Soft-Off by PWR-BTTN
Under ACPI (Advanced Configuration and Power management Interface) you can
create a software power down. In a software power down, the system can be resumed
by Wake up Alarms. This item lets you install a software power down that is controlled
by the power Button on your system. If the item is set to Instant-Off, then the power
button causes a software power down. If the item is set to Delay 4 Sec, then you have
to hold the power button down for four seconds to cause a software power down.
3-9 PnP/PCI Configurations
IRQ Resources
Names the interrupt request (IRQ) line assigned to the USB on your system. Activity
of the selected IRQ always awakens the system.
PCI/VGA Palette Snoop
This item is designed to overcome problems that can be caused by some
non-standard VGA cards. This board includes a built-in VGA system that does not
require palette snooping so you must leave this item disabled.
3-10 PC Health Status
This section shows the Status of you CPU, Fan, and Warning for overall system status.
This is only available if there is Hardware Monitor onboard.