Jetway Computer NF95A - Manual (Page 39)

34
V/H SYNC+Blank This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blanks to the video buffer.
DPMS Initial display power management signaling.
Video Off in Suspend
The optional settings are: No; Yes.
Suspend Type
The optional settings are: Stop Grant; PwrOn Suspend.
MODEM Use IRQ
If you want an incoming call on a modem to automatically resume the system from a
power-saving mode, use this item to specify the interrupt request line (IRQ) that is
used by the modem. You might have to connect the fax/modem to the motherboard
Wake On Modem connector for this feature to work.
Suspend Mode
The optional settings are Disabled; and setting range from 1 Min. to 1 Hour.
Soft-Off by PWRBTN
Under ACPI (Advanced Configuration and Power management Interface) you can
create a software power down. In a software power down, the system can be resumed
by Wake up Alarms. This item lets you install a software power down that is controlled
by the power Button on your system. If the item is set to Instant-Off, then the power
button causes a software power down. If the item is set to Delay 4 Sec, then you have
to hold the power button down for four seconds to cause a software power down.
ERP (EUP) Function
The optional settings are: Enabled; Disabled. When set as Disabled, user can select
the relative items for wake up events: Wake-Up by PCI Card; Power On by Ring;
Wake-Up by USB KB from S3(S4); PS2 KB/MS Wake-Up from S3-S5; Resume by
Alarm.
Resume by Alarm
When set to Enabled, additional fields become available and you can set the date
(day of the month), hour, minute and second to turn on your system. When set to 0
(zero) for the day of the month, the alarm will power on your system every day at the
specified time .