Jetway Computer NC9KDL - Manual (Page 26)

21
Use this item to set USB mass storage device start unit command time-out.
Device power-up delay
Use this item to set maximum time the device will take before it properly reports
itself to the host controller. ‘Auto’ uses default value: for a root port it is 100 ms, for
a hub port the delay is taken from hub descriptor. The optional settings: [Auto];
[Manual].Select [Manual] you can set value for the following sub-item:
Device Power-up delay in seconds, the delay range in from 1 to 40 seconds in
one second increments.
► Super I/O Configuration
► COM1 Port Configuration
Press [Enter] to make settings for the following items:
Serial Port
Use this item to enable or disable serial port (COM1).
Change Settings
Use this item to select an optimal setting for super IO device.
► Parallel Port Configuration
Press [enter] to make settings for the following items:
Parallel Port
Use this item to enable or disable parallel port (LPT/LPTE).
Change Settings
Use this item to select an optimal setting for super IO device.
Device Mode
Use this item to change the printer port mode.
► PC Health Status
Press [Enter] to view hardware health status.
► Clock Generator Configuration
Clockgen Spread Spectrum