Jetway Computer NF9G - Manual (Page 36)

31
Adjacent Cache Line Prefetch
Use this item to turn on/off prefetching of adjacent cache lines.
► SATA Configuration
Press [Enter] to make settings for the following sub-items:
SATA Controller(s)
The optional settings are: [Disabled]; [Enhanced].
IDE Legacy/Native Mode Select
The optional settings are: [Native]; [Legacy].
SATA Mode Selection
The optional settings are: [IDE]; [AHCI]; [RAID].
► Intel(R) Rapid Start Technology
Use this item to enable or disable Intel(R) Rapid Start Technology.
*Note: This item may be not available, depending on different hardware
configuration.
► PCH-FW Configuration
Press [Enter] to see ME information and make settings for Firmware Update
Configuration.
Firmware Update Configuration
Press [Enter] to make settings for ME FW Image RE-Flash.
ME FW Image RE-Flash
Use this item to enable or disable ME FW Image Re-Flash function.
► AMT Configuration
Press [Enter] to make settings for the following sub-items:
Intel AMT
Use this item to enable or disable Intel Active Management Technology.
BIOS Hotkey Pressed
The optional settings are: [Disabled]; [Enabled].
MEBx Selection Screen
The optional settings are: [Disabled]; [Enabled].
Hide Un-Configure ME Confirmation
The optional settings are: [Disabled]; [Enabled].
MEBx Debug Message Output