Diamond D400.1 - Manual (Page 13)

13
+12V GND REM
2
MIN
POWER
PROTECT
SPEAKER
FUSE 20A X 2 FL FR RL RR +12V GND REM
2
MIN
POWER
PROTECT
SPEAKER
FUSE 20A X 2 FL FR RL RR
+12V GND REM
2
MIN
POWER
PROTECT
SPEAKER
FUSE 20A X 2 FL FR RL RR
D300.4, D600.4
4-Channel Amplifier
4 Channel Mode, 1 speaker per channel 3 Channel Mode, 1 pair stereo plus one bridged channel
2 Channel Mode, both pairs of channels bridged
D300.2
2-Channel Amplifier
+12V GND REM FUSE POWER
PROTECT 2
MIN
SPEAKER
L R +12V GND REM FUSE POWER
PROTECT 2
MIN
SPEAKER
L R
2 Channel Mode, 1 speaker per channel Bridged Mode
+12V GND REM
1
MIN
POWER
PROTECT SPEAKER
D400.1, D600.1 D1000.1
Mono Amplifier
If you are connecting more than one speaker per channel, please see the next section.
Mono Mode (This is the only configuration for this amplifier)
Left Speaker Right Speaker
FR Speaker
FL Speaker
RR Speaker RL Speaker FR Speaker
FL Speaker
Subwoofer
Connecting Multiple Speakers
If you must connect more than one speaker per channel, there are two methods in which to do so:
Series or Parallel. Parallel connections are harder on the amplifier than series connections, as the
total impedance is lower compared to driving a single speaker, and the amplifier must produce
more current to drive them. The following diagrams show “bridged” connections from the amplifier.