InSinkErator WX-300 - Manual (Page 7)

8
STANDARD MOUNTING ASSEMBLY
1. Place mounting fl ange (1) over the existing collar
adaptor connection lip or sink bowl fl ange (this may
require some force).
2. Push the mounting fl ange up out of the way and fi t
the groove in the mounting gasket (2) onto the
connection lip. Make sure the gasket is fully seated
on the fl ange.
3. Push the mounting fl ange down over the mounting
gasket,
fi tting the threaded mounting fl ange fasteners
into the recesses in the top of the mounting gasket.
4. From the bottom, insert two screws through opposite
sides of the fl at gasket (3) and mounting fl ange, into
the threaded fasteners in the existing fl ange. The
fl at gasket is used only in the #6 mounting assembly.
The screws should protrude about 1/4 inch below the
mounting
gasket.
5. Position the disposer beneath the mounting gasket
and raise it to engage the two protruding screws in
the disposer body fl ange keyhole slots. Secure the
remaining screws and position the disposer correctly
for the plumbing connections. If disposer legs are
included, adjust the legs to support the disposer.
SPECIAL INSINKERATOR MOUNTING ASSEMBLIES
When installing an InSinkErator Foodservice disposer to a non-InSinkErator sink bowl, a special mounting adaptor
kit is required. The special mountings are described in the Mounting Adaptor Selection Guide (for more information,
call 1-800-845-8345 or go to www.insinkerator.com). Figures 8-10 show examples of non-InSinkErator style sinks.
(Mounting instructions are included in each special mounting adaptor kit.)
#6 Collar Adaptor
(1) Mounting Flange
(2) Mounting Gasket
(3) Flat Gasket
Disposer Body Flange
1/4” Screw
#7 Collar Adaptor
(1) Mounting Flange
(2) Mounting Gasket
1/4” Screw
Disposer Body Flange
Figure 6. #6 Mounting Assembly Figure 7. #7 or Sink Bowl Mounting Assembly
Figure 8. Outward Flange Figure 9. Inward Flange Figure 10. Straight Flange
InSinkErator Mounting Assemblies