beautypg.com

Dukane 28A8751 User Manual

Page 25

background image

ENGLISH-15

ENGLISH

O

O

P

P

E

E

R

R

A

A

T

T

I

I

O

O

N

N

S

S

(

(

c

c

o

o

n

n

t

t

i

i

n

n

u

u

e

e

d

d

)

)

No Signal Menu

The same adjustments and settings are available with the Image and
Options menus when the MENU button is pressed during display of the
“NO INPUT IS DETECTED ON ***” or “SYNC IS OUT OF RANGE
ON ***” message while no signal is received.

Table 8. No Signal Menu

VOLUME

BLANK

MIRROR

START UP

MENU COLOR

LANGUAGE

AUTO OFF

SYNC ON G

WHISPER

16

Item

Description

VOLUME

Volume Adjustment: Reduce VOLUME

Increase VOLUME

• When this function is used, audio input is automatically switched to video. The
audio input can be switched by moving the DISK PAD left and right during the
display of the volume adjustment bar. The volume adjustment bar is displayed by
pressing VOLUME

or VOLUME

button.

BLANK

Select Blank Screen Color: Select the color with the

and

buttons.

•The image is cleared and the entire screen is displayed in the selected color,
when BLANK mode is set with BLANK ON, or when there is no signal for 5
minutes.

MIRROR

Operation Start/Stop: Press the

/

button.

Select Mirror Status: Select the mirror status with the

and

buttons.

START UP

Operation Start/Stop: Press the

/

button.

Setup Initial Screen Display: Select the TURN ON with the

button.

Clear Initial Screen Display: Select the TURN OFF with the

button.

• Note that if TURN OFF is selected the blank screen is displayed in blue when there is no signal.

MENU COLOR Select Menu Background Color: Select the color with the

and

buttons.

LANGUAGE

Operation Start/Stop: Press the

/

button.

Select Menu Display Language: Select the language with the

and

buttons.

AUTO OFF

Operation start/stop: Press the

/

button.

Set AUTO OFF: Set 1~99 minutes with the

and

buttons. The

system automatically enters the standby mode when a signal is not
received for the set time.
Clear AUTO OFF: Select the STOP (0 min.) with the

button. When

the STOP is selected the system does not enter the standby mode even
if no signal is received.

SYNC ON G

Operation Start/Stop: Press the

/

button.

SYNC ON G Valid: Select the TURN ON with the

button.

SYNC ON G Invalid: Select the TURN OFF with the

button.

• May not be displayed correctly with some input signals when the SYNC ON G is
valid. In such cases, remove the signal connector so that no signal is received,
set the SYNC ON G to invalid, and reconnect the signal.

WHISPER

Operation Start/Stop: Press the

/

button.

Set/Clear Wisper Mode: Press

/

button. When the WHISPER is

selected, the WHISPER mode is active. In the WHISPER mode,
acoustic noise level from the unit is reduced, brightness level on screen
is a little lower.