IBASE IB704 - Manual (Page 32)

BIOS SETUP
28 IB704 User’s Manual
Integrated Peripherals
This section sets configurations for your hard disk and other integrated
peripherals. The first screen shows three main items for user to select.
Once an item selected, a submenu appears. Details follow.
Phoenix - AwardBIOS CMOS Setup Utility
Integrated Peripherals
Master Drive PIO Mode Auto ITEM HELP
Slave Drive PIO Mode Auto Menu Level >
IDE Primary Master UDMA Auto
IDE Primary Slave UDMA Auto
IDE DMA transfer access Enabled
IDE HDD Block Mode Enabled
Onboard LAN Boot ROM Disabled
Onboard FDC Controller Enabled
Onboard Serial Port 1 3F8/IRQ4
Onboard Serial Port 2 2F8/IRQ3
UART Mode Select Normal
Onboard Parallel Port 387/IRQ7
Parallel Port Mode SPP
Master Drive / Slave Drive PIO Mode
These fields allow your system hard disk controller to work faster. Rather
than have the BIOS issue a series of commands that transfer to or from
the disk drive, PIO (Programmed Input/Output) allows the BIOS to
communicate with the controller and CPU directly.
The system supports five modes, numbered from 0 (default) to 4, which
primarily differ in timing. When Auto is selected, the BIOS will select the
best available mode.
IDE Primary/Secondary Master/Slave UDMA
These fields allow your system to improve disk I/O throughput to
33Mb/sec with the Ultra DMA/33 feature. The options are Auto and
Disabled.
IDE HDD Block Mode
This field allows your hard disk controller to use the fast block mode to
transfer data to and from your hard disk drive.
Onboard LAN Boot ROM
This feature allows users to enable or disable the onboard LAN boot
ROM. The default setting is Disabled