IBASE IB815 - Manual (Page 21)

INSTALLATIONS
IB815 User’s Manual 17
ATX Power ON Switch: Pins 5 and 13
This 2-pin connector is an “ATX Power Supply On/Off Switch” on the
system that connects to the power switch on the case. When pressed, the
power switch will force the system to power on. When pressed again, it
will force the system to power off.
Pin # Signal Name
5 Power_ON
13 GND
Reset Switch: Pins 7 and 15
The reset switch allows the user to reset the system without turning the
main power switch off and then on again. Orientation is not required
when making a connection to this header.
Pin # Signal Name
7 RESET
15 GND
Hard Disk Drive LED Connector: Pins 8 and 16
This connector connects to the hard drive activity LED on control panel.
This LED will flash when the HDD is being accessed.
Pin # Signal Name
8 -HDD_LED
16 +5VS
JP20: SPI Debug Port
Signal Name Pin # Pin # Signal Name
2 NC
SPI_CS0 3 4 3V_DUAL
MISO 5 6 -SPI_HOLD0
-SPI_WP0 7 8 SPICLK
GND 9 10 MOSI