IBASE IB892 - Manual (Page 17)

INSTALLATIONS
IB892 User’s Manual 13
J1: SPI Flash Connector (factory use only)
J2: Audio Connector
Signal Name Pin # Pin # Signal Name
LINE-OUT_L 1 2 LINE-OUT_R
JD-OUT 3 4 Ground
LINE-IN_L 5 6 LINE-IN R
JD-IN 7 8 Ground
Mic-In L 9 10 Mic-In R
JD-Mic 11 12 Ground
J4: LPC Connector (factory use only)
J5: System Function Connector
ATX Power ON Switch: Pins 1 and 2
This 2-pin connector is an “ATX Power Supply On/Off Switch” on the
system that connects to the power switch on the case. When pressed, the
power switch will force the system to power on. When pressed again, it
will force the system to power off.
Hard Disk Drive LED Connector: Pins 3 and 4
This connector connects to the hard drive activity LED on control panel.
This LED will flash when the HDD is being accessed.
Pin # Signal Name
4 HDD Active
3 5V
Reset Switch: Pins 5 and 6
The reset switch allows the user to reset the system without turning the
main power switch off and then on again. Orientation is not required
when making a connection to this header.
+5V and 5VSB Signals: Pins 7 and 8
Pin # Signal Name
7 +5V
8 +5VSB