Hummer 2004 H2 - Manual (Page 125)

Erasing HomeLink ® Buttons
To erase programming from the three buttons do the
following:
1. Press and hold down the two outside buttons until
the indicator light begins to flash, after 20 seconds.
2. Release both buttons. Do not hold for longer than
30 seconds.
HomeLink ® is now in the train (learning) mode and can
be programmed at any time beginning with Step 2
under “Programming HomeLink
® .”
Individual buttons can not be erased, but they can be
reprogrammed. See “Reprogramming a Single
HomeLink
® Button” next.
Reprogramming a Single HomeLink ®
Button
To program a device to HomeLink ® using a HomeLink ®
button previously trained, follow these steps:
1. Press and hold the desired HomeLink ® button. Do
not release the button.
2. The indicator light will begin to flash after
20 seconds. While still holding the HomeLink ®
button, proceed with Step 2 under “Programming
HomeLink
® .”
Resetting Defaults
To reset HomeLink ® to default settings do the following:
1. Hold down the two outside buttons for about
20 seconds until the indicator light begins to flash.
2. Continue to hold both buttons until the HomeLink ®
indicator light turns off.
3. Release both buttons.
For questions or comments, contact HomeLink ® at
1-800-355-3515, or on the internet at
www.homelink.com.
Storage Areas
Glove Box
To open your glove box, lift up the latch and pull the
door open.
2-45