Hummer 2009 H2 - Manual (Page 19)

Unfolding the Seatback
{ CAUTION:
If either seatback is not locked, it could move
forward in a sudden stop or crash. That could cause
injury to the person sitting there. Always push and
pull on the seatbacks to be sure they are locked.
To return the seatback to the passenger position:
1. Pull up on the release
lever labeled 1 and
then pull up on
the seatback until the
seatback locks into
the upright position.
2. Push forward on the seatback to make sure it is
locked into position.
Tilting the Seat
1. Fold the seatback forward using the instructions
listed previously.
2. Unlatch the seat from
the floor by pulling up
on the lever labeled 2,
located on the rear
of the seat.
3. Lift the rear of the seat up from the floor and push it
forward until it locks into place. The seat cannot be
unlatched from the floor unless the seatback is
folded down.
The seat will now remain locked in the upright position.
1-15