HuddleCamHD 3X - Manual (Page 8)

Ver 1.1 6/30/14
code can control the dome camera.
SW2: Used for communication settings.
SW2 DIP-1,2,3: Baud Rate, Communication Protocol
SW2 DIP-4,5: IR Remote Control Receiving Address Table
IR Remote Address
SW2 Switch State (4-5)
DIP-4 DIP-5
0 OFF (Def) OFF (Def)
1 OFF ON
2 ON OFF
3 ON ON
SW2 DIP-6: IR Output
IR Out SW2 DIP-6
Disabled OFF (Def)
Enabled ON
Baud Rate SW2 DIP-1 Communication
Mode
SW2 DIP-2 Communication
Protocol
SW2 DIP-3
9600bps OFF (Def) RS-232 OFF (Def) VISCA OFF (Def)
38400bps ON RS-485 ON PELCO-D ON