Dacor MW - Manual (Page 6)

4
I
nstallatIon
s
pecIfIcatIons
27"/30"/36"
Dacor
single oven
Warming Oven
Warming Oven
Toe Kick
1 ¾” Min.
(44mm)
5/8” Min.
(16mm)
D
C
C
A
120 Vac
electrical
outlets
Table 1: Cutouts Dimensions
Stacked Installation with Wall Oven
Model
“A” Cutout
Width
“B” Min. Width
to Adjacent
Doors/Drawers
“C” Cutout
Height
“D” Min. Gap
Between Cutouts
IOWO24 22 9/16” (573mm)
N/A*
12 1/8” (308mm)
N/A*
IWO24
22 1/2” (572mm)
9 1/8” (232mm)
EWO24 24 1/4” (616mm)
1 1/16” (27mm) EW27
25 1/2” (648mm)
27 1/4” (692mm)
EWO27
IWO27 N/A* N/A*
MW27
27 1/4” (692mm)
1 1/16” (27mm)
MWO27
PW27
EW30
30 1/4” (768mm)
EWO30
MW30
MWO30
PW30
PWO30
EWO36 34 3/8” (873mm) 36 1/4” (921mm 3” (76mm)
* Depends on size of cabinet face installed.
I
nstallatIon
p
lannIng
A qualified technician must complete the installation of this
◊
built-in appliance. Proper installation is the responsibility of
the customer.
Carefully check the installation location. The oven should be
◊
placed for convenient access. Make certain that electrical
power can be provided in the selected location.
Plan the installation so that all minimum clearances are
◊
met or exceeded. Dimensions shown provide minimum
clearances, unless otherwise noted. Be certain that proper
clearance is provided for the oven door when it is in the open
position.
The specified minimum cabinet depth and width must be
◊
provided. The cabinet depth and width must completely
enclose the recessed portion of the oven.
Cabinet cutout dimensions must be used as indicated. All
◊
contact surfaces between the appliance and the cabinet must
be solid and level. The oven support platform must be flush
with the bottom edge of the cabinet cutout.
Make certain that you have everything necessary to ensure a
◊
proper installation before proceeding.
NOTES:
1. Minimum Cutout Depth:
Model IOWO24 - 20” (508mm)
All other models - 23 3/8” (594mm)
2. The IOWO24 and EWO36 models cannot be stacked.
3. The IOWO24 warming oven is not approved for
installation under a wall oven.