Hypertherm HT4400 HySpeed Product Configuration - Manual (Page 5)

1-2
S PECIFICATIONS
HT4400 Product Configuration Manual
System Components
Power Supply
The power supply houses four 100-amp, 15 kHz choppers to produce up to 400A of constant current DC out-
put.
Machine Torch
The maximum production cutting capability of the torch is 1-1/4 inches (32 mm). To achieve consumable
long life, all cuts must begin and end on the plate surface.
Valve Cluster
The valve cluster consists of 5 valves and interfaces with the machine torch, the ignition console and the gas
console. The valve cluster must be located within 4 ft (1.2 m) of the torch and within 50 ft (15.3 m) of the gas
console.
Gas Console
This unit houses metering and solenoid valves, pressure readout LEDs and gas selection switches to
choose, set and monitor plasma and shield gases. The gas console must be located within 50 ft (15.3 m) of
the valve cluster.
Ignition Console
The ignition console generates a high voltage, high frequency signal and couples it to the cathode lead and
pilot arc lead. This ignition console must be located within 15 feet (4.6 m) of the torch.
Water Cooler
This unit circulates a coolant solution to the torch. The water cooler interfaces with the ignition console and
the power supply. For more information, see Water Supply Requirements in the Installation section of this
manual.
Remote Current Control Console - Optional
The remote current control console contains a thumbwheel switch to set the arc current. If a machine inter-
face will provide current control for the plasma system, you will not need this console.
Command THC - Optional
The Command THC is an external torch height control and initial height sensing system designed for plasma
cutting applications on an x-y cutting table. Refer to the Command THC instruction manual 802780 for more
detailed information.
3-00