Directed Electronics 719T - Manual (Page 12)

8
© 1999 Directed Electronics, Inc.
■ If the current setting is unacceptable, press to decrease
the sensitivity or to increase the sensitivity. Each time
is pressed, the unit will emit one chirp and the sensitiv-
ity is decreased one step. Each time is pressed, the unit
will emit two chirps and the sensitivity will be increased one
step. There are 16 possible settings. When the maximum or
minimum setting (Warn-Away ™ off) is achieved, the siren will
emit a long chirp.
1. Arm the system by pressing on your transmitter.
2. Within five seconds, press and hold on the transmitter
until the unit generates a long chirp.
3. Release on the transmitter.
Strike the vehicle to test the current setting. If the impact is
detected the unit will chirp three or four times.
■ If the current setting is acceptable do nothing and the unit
will exit shock sensor adjustment mode.
■ If the current setting is unacceptable press to decrease
the sensitivity or to increase the sensitivity. Each time
is pressed, the unit will emit one chirp and the sensitiv-
ity is decreased one step. Each time is pressed, the unit
will emit two chirps and the sensitivity will be increased one
step. There are 16 possible settings. When the maximum set-
To Test and Adjust the Current Full Trigger Setting
Adjusting the Shock Sensor Full Trigger