Danby DMW104W - Manual (Page 9)

POWER PAD
Oven automatically cooks at high power. For a lower
power level, set cook time, touch POWER and enter
number (1-9) for lower power level.
TIMER PAD
Independent kitchen timer. Set any time even while
oven is operating. Touch TIMER pad, set time then
START. Touch RESET to cancel.
COOK PAD
Cook at one power level for a period of time, then
automatically switch to another power level for the
remaining cook time.
COOK BY WEIGHT
Touch COOK BY WEIGHT pad, enter weight of meat
accurately, then START. After partial cooking, oven
stops, leaving time on display. Turn over meat when
oven stops after partial cooking. Re-touch START to
finish. DEFROST BY WEIGHT
Automatic defrosting for large meats. Controls power
level to thaw without excessive outside warming.
SPEED DEFROST
Automatically programs lower power levels for even
defrosting. Touch SPEED DEFROST, set time and
START.
CLOCK
Touch pad once, touch number pads and CLOCK to
set clock.
RESET
Touch to clear display of unused time after cooking,
also cancel timer.
START/STOP PAD
Touch as final step in setting oven. Touch to stop
microwaving while oven is in operation (re-touch to
continue timing shown on display). Will not stop timer.
OPERATING INSTRUCTIONS
1. SETTING THE CLOCK
A. Setting the clock when the oven is plugged in.
l When the oven is first plugged into a wall outlet,
touch the CLOCK pad once, the display will show
“ENTER CLOCK TIME”.
l Enter the correct time of day by touching the
correct number pads. You must set at least 3
digits (one for hour(s) and two for minutes). For
minute less than 10, precede the “minutes” digit
by a 0. Example: for 5 minutes past 2, set 2:05.
The colon will flash between hour and minute
digits. If you prefer not to have the clock displayed,
set the clock for 00:00 and the display will only
show a colon.
l Touch CLOCK to lock in the time.
Colon will stop flashing and clock will begin to
keep current time. After clock has been set, the
word prompt clock will always show on the
display unless oven is in a cooking operation.
B. Changing the clock time.
l
Touch the CLOCK pad once, the display will show
“ENTER CLOCK TIME”
l Enter the correct time of day by touching the
correct number pads. You must set at least 3
digits (one for hour(s) and two for minutes). For
minute less than 10, precede the “minutes” digit
by a 0. Example: for 5 minutes past 2, set 2:05.
The colon will flash between hour and minute
digits. If you prefer not to have the clock
displayed, set the clock for 00:00 and the display
will only show a colon.
l Touch CLOCK to lock in the time.
Colon will stop flashing and clock will begin to
keep current time. After clock has been set, the
word prompt clock and time of day will always
show on the display unless oven is in a cooking
operation.
7