Guntermann & Drunck UserCenter2/4 - Manual (Page 15)

Guntermann & Drunck GmbH Operating Instructions UserCenter 2 (4)
Page 12
6.12 Automatic mouse-reset
With this setting you define whether UserCenter 2(4) sends a mouse-reset to
the computer during the switch-on or not (does not work with Unix computers).
For enabling the automatic mouse-reset proceed as follows:
• Call up the setup mode with CTRL + BACKSPACE
The setup mode will be indicated by the the flashing of the three
keyboard LEDs (NUM-Lock, CAPS-Lock, SCROLL-Lock).
• For enabling press T
• To disable the automatic mouse-reset againg press Z
After enabling/disabling the automatic mouse-reset the setup mode will be
closed automatically. The keyboard LEDs stop flashing.
You can always stop the entry by pressing
ESC .
6.13 Support for the serial Logitech mouse
With this setting you define whether to connect a Logitech or an Intelli mouse to
the serial interface (V.24).
For supporting the serial mouse proceed as follows:
• Call up the setup mode with CTRL + BACKSPACE
The setup mode will be indicated by the flashing of the three keyboard
LEDs (NUM-Lock, CAPS-Lock, SCROLL-Lock).
• For the support press O
• To disable the support again press P
After the mouse support is enabled/disabled the setup will be closed
automatically. The keyboard LEDs stop flashing.
You can always stop the entry by pressing
ESC .