Guntermann & Drunck DevCon-Center Installation - Manual (Page 10)

Using the Reset button
7 · G&D DevCon-Center
Using the Reset button
The Reset button is located between the Identification LED and the RS 485 interface on
the front panel of the computer module and the user module.
This button enables you to reset the default settings as well as to temporarily deacti-
vate the netfilter rules.
Resetting the default settings
Pressing and holding the button during booting resets the default setting of the
DevCon-Center appliance.
How to reset the default settings:
1. Switch off the device if in operation.
2. Press and hold the Reset button on the front panel of the device.
3. Keep the button pressed and switch on the device.
4. Release the button as soon as the green System LED is blinking.
NOTE: As protection against pressing the button accidentally, it is located behind a
drilling in the front panel.
Use a thin, pointed item to press the button.
NOTE: It is also possible to use the Config Panel web application to reset the default
settings (see separate manual).