Daewoo DWD-F1011 EN - Manual (Page 4)

4
Removing transit bolts
1. Before operating the washer, remove the
transit bolts(3ea) along with the rubber.
• If the bolts are not removed, it may cause
heavy vibration, noise and malfunction.
2. Unscrew the 3 bolts with the spanner
supplied. Keep the 3 bolts and spanner for
future use.
• Whenever the appliance is transported, the
transit bolts must be refitted.
3. Close the holes with the cap holders supplied.
Location of washer
• Check location where the washer will be installed. Make sure you have everything necessary for
correct installation.
• Do not place or store your washer below 0°C (32°F) to
avoid any damage from freezing.
• Do not place or store laundry products on top of washer
at any times.
• Install the washer on the horizontal solid floor.
If the washer is installed on an unsuitable floor, it could
make considerable noise, vibrate severely and cause a
malfunction. If the washer is not level, adjust leg up or
down for horizontal installation.
• Leave some space (right & left : 2cm, rear : 10cm).
INSTALLATION INSTRUCTIONS
Laundry
Tub
Washer
approx.
2cm
Drain Hose