Grip Factory Munich GF-Jib Arm User Manual
Page 2
2
2. Hold the front of the jib so that there is no longer any pressure on the rod locking pin 1 (2)
and the jib arm’s weight is now being supported. Carefully remove the rod locking pin 1 and
lower the jib arm onto a suitable support stand.
3. Open extension locks 1 (3) and 2 (4) carefully and pull the front of the arm to the required
working length.
4. Lock extension locks 1 and 2.
5. Insert the counterweight rod, lock securely and fit the adjustment ring to the rod.
6. Open the tilt locks and drags (6 & 7).
6. Mount 2 counterweights to the rod and open the rear extension lock.
7. Crank the weights out until the arm is balanced then secure with the rear extension lock