Complete the assembly, Stool care – Gladiator GAAC30STPB Gladiator Stool User Manual

Page 2

Keeping the leg assembly upright, position the larger ring over
the top of leg frame and move down to align with the lower holes
in the sides of the legs. Insert four

¹ ₄" x 1³ ₄" pan-head machine

screws through the larger ring then through the leg. Attach four

¹ ₄"—20 hex lock nuts and finger tighten.
NOTE: Do not tighten the screws and nuts completely until after
leveling the leg frame.

Place the leg frame upside down on the cardboard. Insert the
smaller ring into the center of the leg frame and push down until
the smaller ring holes align with the holes inside the legs. Insert
the four #14 sheet metal screws through the smaller ring and into
the legs.
NOTE: Do not tighten the sheet metal screws completely until
after leveling the leg frame. See Step 4.

Turn the leg frame assembly upright and check to be sure it is
level. If the assembly rocks back and forth or seems unsteady,
tap the legs against the floor until all four legs rest firmly on the
floor.
NOTE: When testing the balance of the leg frame assembly, use
a level floor surface. If the leg frame assembly remains
unbalanced, repeat Step 4.

When leg frame is balanced, using a Phillips screwdriver and a

⁷⁄₁₆" wrench securely tighten all bolts and screws.

Place the swivel plate (flat side up) across the bars on top of the
leg frame assembly. Align the swivel plate holes of the plate
closest to the frame with the frame holes. Insert four 1

¹ ₄" pan-

head machine screws through swivel plate and leg. Secure
swivel plate using four

¹ ₄"—20 hex lock nuts and tighten

securely.

Place the seat (upholstered side down) on the cardboard to avoid
scratching. Turn the leg frame assembly with swivel plate facing
down toward the seat and align the swivel plate holes with the
seat holes. Fasten the leg frame and swivel plate assembly to the
seat using four

¹ ₄"—20 x 1" pan-head machine screws. Tighten

securely.

Complete the Assembly

Stand the stool upright and place in its final location.

Stool Care

Wash the stool with a mild liquid detergent and warm water using
a soft, clean cloth.

Rinse completely and dry thoroughly with a soft, clean cloth.
NOTE: To avoid damage to the stool, do not use abrasives,
flammable fluids, or harsh chemicals to clean the stool.

2253809A

® Registered Trademark/TM Trademark of Whirlpool, U.S.A.

7/04

Printed in U.S.A.