Gladiator GAWB66BAWG The 66.5 Bamboo Modular Workbench - Manual (Page 3)

3
ASSEMBLY INSTRUCTIONS
Tools and Parts
Gather the required tools and parts before starting installation.
Tools Needed:
Parts Supplied:
Workbench Use Requirements
■ Intended for use in a garage.
■ 66.5" (169 cm) Bamboo Workbench - Maximum weight limit is
300 lbs (112 kg).
■ 73" (185.4 cm) Bamboo Workbench - Maximum weight limit is
750 lbs (280 kg).
Unpack the Workbench
1. Unpack the legs, braces and hardware from the box. Verify
contents. See “Parts Supplied.”
NOTE: Leave the workbench top on the cardboard during
assembly.
2. Remove the corners from the workbench top. The predrilled
holes should be visible.
3. Dispose of/recycle all packaging materials.
Install Legs and Angle Braces
IMPORTANT: The predrilled holes in the underside of the workbench
top are along the rear edge of the workbench.
1.
With the rivet nuts facing inward, and the holes to the rear of the
bench, place each pair of legs on the underside of the top and
align the holes in the plate with the predrilled holes in the
workbench top.
2. Using eight lag screws (four screws per pair), fasten the legs to
the workbench top. Do not completely tighten the screws.
3. Align the holes in the angle braces with the holes in the
workbench top and the holes in the legs.
IMPORTANT: The angle braces are left-hand side and right-hand
side specific. If the hole pattern doesn’t match on one side, try
the other side.
■
¹⁄₂" Socket wrench
■ Workbench top
■ Workbench legs
(2 welded pairs)
■ Right angle brace
■ Left angle brace
■ Leveling foot (4)
■ ⁵⁄₁₆" Allen head bolts (6)
■
⁵⁄₁₆" x 1¹⁄₈" Lag screws (12)
■ Allen wrench
⁵⁄₁₆" Allen head bolt ⁵⁄₁₆" x 1¹⁄₈" Lag Screw
WARNING
Excessive Weight Hazard
Use two or more people to move and assemble
workbench.
Failure to do so can result in back or other injury.
A. Lag screws
A