Gladiator GAWC042PZY GearTrack Channels 4' (2 Pack) - Manual (Page 2)

Install the GearTrack® Channels
Masonry Block/Poured Concrete Wall
1. Use a level to position the GearTrack® Channel at the desired height
on the wall.
2. Drill a hole through the GearTrack® Channel and into the wall surface.
3. Secure the GearTrack® Channel to the wall by placing
3 ⁄
16
" x 1 3 ⁄
4
"
(4.45 cm) flat-head masonry screws every 24" (60.96 cm) in every slot.
NOTE: Channels cut to shorter than 24" (60.96 cm) long should not
be used.
4. For extra hold, you may put construction adhesive on the GearTrack®
Channel before attaching it to the wall.
5. Repeat this process for the next desired application area.
6. Make sure all screws are installed and flush with the channel.
Drywall over Wooden Studs or Bare Wooden Studs
1. Locate all wooden studs and electrical wiring. Mark the wall(s).
IMPORTANT: Compare screw length to electrical wire locations. Be
sure the screw will not pierce electrical wiring.
2. GearTrack® Channels should be mounted to the wall so that they
begin and end at wooden studs. Measure from the edge of the stud
at the beginning of the desired coverage area to the center of the
last wooden stud that is within 32" (81.3 cm) or 48" (121.9 cm) or 53.15"
(135 cm) depending on the length of your GearTrack® channel.
3. If necessary, cut the first channel to this length, making sure the cut
is square.
NOTE: Channels cut to shorter than 24" (60.96 cm) long should not
be used.
4. Check that the GearTrack® Channel is level. Then place a screw in
every slot at every stud location.
NOTE: Drive the screws through the slot groove until they are flush.
If splitting occurs, predrill and countersink the screw holes near
channel ends.
5. Repeat this process for the next desired application area.
6. Make sure all screws are installed and flush with the channel.
Install the GearTrack® Channel End Caps
OR
Warranty
For warranty information:
In the U.S.A., visit our website at www.GladiatorGW.com or call
1-866-342-4089.
In Canada, visit our website at www.gladiatorgarageworks.ca or call
1-800-807-6777.
See complete markings on product.
MEETS INTERIOR USE CLASS A FIRE CODES
W10343308B
© 2011 Whirlpool Corporation. 12/11
All rights reserved. ® Registered Trademark/TM Trademark of Whirlpool, U.S.A., Whirlpool Canada LP Licensee in Canada Printed in China
From the side, slide the end
cap onto each end of the
GearTrack® Channel. From the front, snap the end
cap onto each end of the
GearTrack® Channel.