Gladiator GALG36CKXG Mobile Storage Cabinet - Manual (Page 5)

5
To install leveling legs:
1.
Place the cabinet on its side.
2. Screw a leveling leg (P4) into each of the four rivet nuts located at
the corners of the cabinet as shown.
3. Stand the cabinet upright.
Install Shelves
The shelves are supported by the metal slots on the cabinet sides.
IMPORTANT:
■ Install shelf (P5) in the center of the cabinet so the door will lock.
■ Install shelves (P5m) in the cabinet so that one is above and one
is below center shelf (P5) to best use the magnetic closures.
Make sure the long edges with the magnets are facing the
cabinet front.
1. Place shelf (P5) so that the two tabs in the shelf ends are aligned
with the pair of slots in the middle of the cabinet sides.
2. Tilt the shelf so that one end is higher than the other as shown.
3. Insert the shelf into the cabinet so that the higher end is directly
above the desired slots and push the shelf down into place
behind the side slots. Raise the lower end so it is directly above
the desired slots and push the shelf down.
NOTE: You may need to slightly bend the shelf tabs outward for
the tabs to engage in the slots. Make sure the shelf tabs are in
place behind all the slots, as shown.
4. Repeat steps 2 and 3 for the remaining two shelves.
Adjust the Shelves
1. Lift up on the underside of the shelf until the shelf tabs are free of
the cabinet slots.
2. Tilt the shelf up to reposition it within the cabinet or to remove it
from the cabinet.
A. Leveling legs
A. Middle pair of slots in cabinet side
A
P3
P1
P4
P10
A
P1
P2
P1
P3
P5
A. Push down.
B. Lift up.
A. Cabinet slot
B. Shelf tab
A
B
A
B