Gladiator GAWG28KDYG Gladiator Ready-To-Assemble 3/4 Wall GearBox - Manual (Page 5)

5
Install Doors
The door hinges are designed with keyhole slots at the top and
bottom so the door will hang on the cabinet while you are fastening
the screws.
1.
Start Phillips-head screws (F3c) in both the top and bottom holes
on each side of the cabinet.
2. Hang the right-hand side door (P7) from the top and bottom
screws, and hand tighten.
3. Insert the middle screw through the door hinge into the cabinet
and hand tighten.
4. Repeat steps 2 and 3 to attach the left-hand door (P8).
5. Align the doors and tighten the screws completely.
INSTALLATION INSTRUCTIONS
IMPORTANT: Decide whether you are going to mount the cabinet on
Gladiator
® GearWall ® panels or GearTrack ® channels, or on a
standard wall. Follow the instructions that apply to your installation.
Install Cabinet to GearWall ® Panels
or GearTrack ® Channels
IMPORTANT:
■ Be sure the GearWall ® panels or GearTrack ® channels are
installed with mounting screws in every slot and at every stud
location with a maximum of 24" (60.96 cm) horizontally between
screws.
■ If you are mounting the cabinet on GearTrack ® channel, a second
channel should be installed 18" (46 cm) below the bottom of the
supporting channel so the cabinet will hang level.
Attach Mounting Bracket
1. With the mounting bracket (P9) rim pointing down, align the
2 bracket holes with the 2 holes in the top back panel (P4).
2. Working from the back, insert 2 carriage bolts (F7) through the
bracket and top back panel (P4).
3. Working from the cabinet interior, fasten each bolt with a
washer (F8) and a flange nut (F2). Tighten the bolts completely.
4. Close the cabinet doors.
F3c
F3c. Phillips-head screw (6)
P1
P3
P6
P6m
P2
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet.
Failure to do so can result in back or other injury.
18" (46 cm)
F7 F8 F2
F7. Carriage-head bolt (2)
F8. Washer (2) F2. ⁵⁄₁₆" Flange nut (2)
A. Bracket rim pointing down
P9
P1
P4
P2
A
P2
P4
P9
P1