Dynex DX-208 - Manual

Dynex headset with removable microphone • DX-208
Casque d’écoute avec microphone amovible
Auriculares con micrófono desmontable Dynex
Using the headset
Installing your headset
To install your headset
Plug the green and pink connectors into the
corresponding ports on your computer. If you
are prompted with the Add New Hardware
Wizard, follow the steps to download and
install the driver.
Testing your headset
To test your headset
1. Plug in your headset.
2. Start the Sound Recorder application (Click Start, then select All
Programs, Accessories, Entertainment).
3. Click Record and speak into the headset for 5–10 seconds.
4. Click Stop, then Play. If you can hear your recording through the headset, it is working correctly.
Adjusting the volume
You can adjust the volume by turning the volume knob on the headset, or using the Windows volume
control in the Control Panel. Your computer may also have volume buttons to adjust the Windows
volume control.
Troubleshooting
If your headset does not function correctly, try the following:
• Make sure your headset is properly
plugged into the correct ports.
• Make sure the volume is set to a
medium level, and is not muted.
Legal notices
FCC statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit diff erent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
ICES - Canada’s Interference-Causing Equipment Standards This equipment complies with the applicable technical standards of ICES
003:1997 in accordance with the measurement procedures specifi ed in CISPR22-96.
Copyright © 2007 Dynex. DYNEX and the DYNEX logo are trademarks of Best Buy Enterprise Services, Inc. Other brands and product
names are trademarks or registered trademarks of their respective holders. Specifi cations and features are subject to change without
notice or obligation.
One Year Limited Warranty
For complete warranty go to www.dynexproducts.com.
Utilisation du casque d’écoute
Installation du casque d’écoute
Pour installer le casque d’écoute
Pour installer votre casque d’écoute, branchez
les connecteurs vert et rose sur les ports
correspondants de l’ordinateur.
Si l’Assistant ajout de nouveau matériel (Add New
Hardware Wizard) s’affi
che, suivez les étapes pour
télécharger et installer le pilote.
Test du casque d’écoute
Pour tester le casque d’écoute
1. Branchez le casque d’écoute.
2. Démarrez l’application Sound Recorder [Magnétophone] (Cliquez
sur Start [Démarrer] puis sélectionnez All Programs [Tous
les programmes], Accessories [Accessoires], Entertainment
[Divertissement]).
3. Cliquez sur Record (Enregistrer) et parlez dans le casque d’écoute
pendant cinq à 10 secondes.
4. Cliquez sur Stop (Arrêter) puis sur Play (Lecture). Si vous pouvez entendre votre enregistrement en
Quick Installation Guide
Guide d’installation rapide • Guía de instalación rápida