Dual SXSERIES SX652 - Manual (Page 4)

4
SX SERIES INSTALLATION
Mounting
1. Determine where the speakers will
be mounted. Make sure the area
is large enough for the speaker
to mount evenly. Also ensure the
mounting location is deep enough for
the speaker to fit.
2. Refer to the specification chart to
determine the proper diameter hole
to cut for your speaker model.
3. If supplied, use the plastic mounting
ring as a template to mark the
locations for the mounting screws.
Drill the holes with a 3/32" bit.
4. Be sure to observe proper polarity
when connecting the wires.The
speaker's positive terminal is
indicated with a "+" symbol.
5. Fit the speaker to the hole cut-out.
Mount the speaker using the
supplied screws. If the speaker grill
is to be used, insert 4 screws into
the grill holes and then mount the
speaker.
Standard Rear Deck Installation
Mounting hole
Cut-out
Grille
Speaker
Standard Door Installation
Grille
Speaker
Mounting hole
Cut-out