GamuT M250i - Manual (Page 3)

SAFETY INSTRUCTIONS:
Never let children (or grownups) push anything into holes or slots in the case - this could result
in an electric shock and could cause damage of the set.
Never guess or take chances with electrical equipment of any kind - it is better to be safe than
sorry.
Warning: To prevent fire or shock hazard do not expose this appliance to rain or moisture
No user serviceable parts inside. Refer servicing to a qualified technician. Never remove covers
unless qualified to do so. This unit contains dangerous voltages.
DO read the user’s guide before you attempt to use this equipment.
DO ensure that all electrical connections are properly set in accordance with the manufacturer’s
instructions (this includes the mains plug, extension leads and interconnections between pieces
of equipment).
DO check that the mains fuse rating is set correct for your local mains voltage.
DO NOT obstruct the necessary all-around ventilation: Especially DO NOT place the set close to
curtains or on soft furnishing such as carpets. Overheating can cause unnecessary damage and
shorten the life of the set.
DO NOT switch the amplifier on, then off, then on again quickly. The blue light must disappear
completely before you switch on again. Only switch on and off using the power switch.
DO NOT unplug the mains cables while they carry current. This will corrode and damage the
surface of the metal of the mains plugs and sockets. This can cause reduced sound quality and
electrical fires.
The mains switches have special metals in the contact points selected for handling high in-rush
currents, as well as to break large currents. Plugs and sockets are not made of such metals.
DO NOT use the ‘direct’ speaker output for tests with square waves or sine waves and a capacitor
across the output terminals, as you may damage the amplifier.
DO NOT connect output ground to input ground. Do not connect any output grounds together.
DO NOT connect headphones to this amplifier without using protecting resistors.
Make sure that you do not let any tiny part of the speaker cable going to a terminal touch the
other terminals. Only connect this amplifier to loudspeakers, and only one loudspeaker on each
channel. Do not connect the output of this amplifier to another amplifiers outputs or inputs.
DO NOT connect a red terminal to another red terminal.