GAMMA X-Stringer X-ST STRINGING MACHINE (Issue 2 - October 2009) - Manual (Page 7)

6
Adjusting the Frame Support Posts
Loosen the lock bolts of the frame support
posts and space them apart with the frame
support slides separated by the approxi-
mate length of the racquet head. Although it
is not required, it is good practice to center
the support posts on the turntable. Lock one
of the posts in position by tightening the lock
bolt and position the other post until the frame
support slide is positioned near the inside
surface of the racquet frame. Securely
tighten the lock bolt of the second support
post.
Caution: To avoid racquet damage, the center posts should not contact the racquet prior to
locking down the support posts.
Tightening the Frame Supports
Tighten the Frame Support Slides by turning
the adjustment knob clockwise until snug
against the racquet frame and slight resis-
tance is felt.
Caution: Overtightening the Center Sup-
ports will stretch the head of the racquet and
could cause racquet damage.
MOUNTING THE FRAME
Frame Shoulder Support Adjustment
Being sure the shoulder supports are free
to swivel in their mountings, simultaneously
rotate the shoulder support adjustment knobs
clockwise until both shoulder supports gen-
tly and squarely contact the frame.