Care and maintenance, Belts, Belt tension – Dixon Grizzly 2006 User Manual

Page 37

Text mode
Original mode

CARE AND MAINTENANCE

BELTS:

Check belts every 50 hours. Replace any belts found to
be in poor condition.

BELT TENSION:

Mower Deck Serpentine Belt

P/N 1300 (50”) 9758 (60”)

Manual adjustment.

Refer to illustrationfor adjustment procedure.

Engine to Mower Deck Belt

P/N 18282 (50”) 18280 (60”)

The engine to mower deck drive belts are automatically
held in proper tension by springs which push the deck
assembly forward and do not require any additional
adjustment to be made.

Note:

Belt deflection or movement should be approximately
1/4” when measured at mid-point between pulleys.
Periodically inspect both belt and idler systems.

Idler Weldment

3/4”

(50” & 60” Serpentine)

“L” Rod

Idler Shock Mount

Hex Nut

Tighten or Loosen

Hex Nut to achieve

this dimension