Fusion CP-AS1080 v3 - Manual (Page 2)

PUBLISHED BY FUSION ELECTRONICS LIMITED: © Copyright 2011 by FUSION Electronics Limited. All rights reserved. Specifications and design are subject to change without notice. v3.0
YOU CAN HELP PROTECT THE ENVIRONMENT! Please remember to respect the local regulations: Hand in the non-working electrical equipment to an appropriate waste disposal center.
RECORD YOUR PURCHASE DETAILS HERE:
SERIAL NUMBER
DATE OF PURCHASE
AFFIX RECEIPT HERE
WARNING: Audio Systems can produce sound levels over 135dB. Continuous exposure to sound pressure levels over 100dB may cause permanent
hearing loss! Please watch for emergency vehicles as warning signals may not be heard. USE COMMON SENSE!
TROUBLE SHOOTING
Problem
Possible Reason Solution
Not switching on.. • No +12V to power wire • Check fuses and connections to battery
Power LED not ‘on’. • No power to remote wire • Check remote on connections to head unit
• Fuse broken • Replace fuse with correct type and amperage
Not working, but status • Fuse blown • Replace fuse with correct type and amperage
LED is ‘on’ • Amplifier too hot • Move amplifier to vented area
• Turn head unit down
No Sound • RCA Signal • Check RCA connection to head unit
• Gain control not set up • Ensure you have set up the amplifier gain level control
• Head Unit • Check head unit volume level
• Connections • Check all power, remote on and ground connections
For further product and installation information, please visit www.fusionelectronics.com
Pour plus d’informations sur les produits et l’installation, rendez-vous sur www.fusionelectronics.com
Para obtener más información acerca de los productos y de su instalación, visite el sitio web www.fusionelectronics.com
Bezoek www.fusionelectronics.com voor meer product- en installatie-informatie.
Weitere Produkt- und Installationsinformationen finden Sie unter www.fusionelectronics.com
Per ulteriori informazioni sui prodotti e la loro installazione, potete visitare www.fusionelectronics.com
Для получения дополнительной информации о продуктах и установке зайдите, пожалуйста, на: www.fusionelectronics.com
LEVEL CONTROL
This control is used to match the input level of the amplifier to
the output level of your head unit. We recommend the following
method.
1. Turn the amplifier level to zero
2. Turn the volume of the head unit to ¾ & the bass & treble to zero
3. Adjust the level control until the desired maximum volume is
achieved without distortion
4. Failure to follow these steps may cause permanent damage to
the audio system
LOW PASS FILTER
Ensure the crossover frequency is set at 120Hz or below. This
feature is designed to filter out all mid to high frequencies that only
full range speakers should produce
BASS BOOST
Set the bass boost level to increase the bass at 45Hz. Selectable
from 0dB - 12dB gains
REMOTE CONTROL LEVEL INPUT
Attach the remote level control (via the included cable) to control
the volume level of the subwoofer independently at the front of the
vehicle.
PHASE SHIFT (0-180 DEG)
Use this switch to help compensate for time alignment problems
in the system. Such problems usually result from having the
subwoofer at a different distance from the listener than the other
speakers in the system.